Each G22 handle should be deallocated to avoid memory leaks. Therefore, g22zaf should be called on all such handles which are no longer needed. Please note that passing an uninitialized handle might cause unpredictable behaviour, including a crash of your program.

4 References

None.

5 Arguments

1: $handle$ – Type (c_ptr) Input/Output: On entry: the G22 handle to be destroyed.

On exit: the handle is destroyed and set to c_null_ptr.
2: $ifail$ – Integer Input/Output: On entry: ifail must be set to $0$ , $- 1$ or $1$ to set behaviour on detection of an error; these values have no effect when no error is detected.
A value of $0$ causes the printing of an error message and program execution will be halted; otherwise program execution continues. A value of $- 1$ means that an error message is printed while a value of $1$ means that it is not.

If halting is not appropriate, the value $- 1$ or $1$ is recommended. If message printing is undesirable, then the value $1$ is recommended. Otherwise, the value $0$ is recommended. When the value $- 1$ or $1$ is used it is essential to test the value of ifail on exit.

On exit: $ifail = 0$ unless the routine detects an error or a warning has been flagged (see Section 6).

6 Error Indicators and Warnings

If on entry

ifail = 0

- 1

, explanatory error messages are output on the current error message unit (as defined by x04aaf).

Errors or warnings detected by the routine:

$ifail = 11$: handle has not been initialized.

$ifail = 12$: handle has been corrupted.

$ifail = 13$: handle is a handle to an unknown data structure.

$ifail = - 99$: An unexpected error has been triggered by this routine. Please contact NAG.
See Section 7 in the Introduction to the NAG Library FL Interface for further information.

$ifail = - 399$: Your licence key may have expired or may not have been installed correctly.
See Section 8 in the Introduction to the NAG Library FL Interface for further information.