e04rwf is a part of the NAG optimization modelling suite. It allows an Integer piece of information to be read from or written to the problem stored in the handle. For example, it may be used to extract the current problem sizes and statistics.
The routine may be called by the names e04rwf or nagf_opt_handle_set_get_integer.
e04rwf adds an additional means of communication to routines within the NAG optimization modelling suite. It allows you to either read or write a piece of information in the handle in the form of an integer array. The item is identified by cmdstr and the direction of the communication is set by ioflag. The functionality is limited in this release of the NAG Library to the retrieval of the problem size and statistics.
General information on available cmdstr is as follows.
On exit: the correct expected dimension of iarr if liarr does not match the item identified by cmdstr (in this case e04rwf returns ).
5: – Integer arrayInput/Output
On entry: if (write mode), iarr must contain the information to be written to the handle; otherwise, it does not need to be set.
On exit: if (read mode), iarr contains the information requested by cmdstr; otherwise, iarr is unchanged.
6: – IntegerInput/Output
On entry: ifail must be set to , or to set behaviour on detection of an error; these values have no effect when no error is detected.
A value of causes the printing of an error message and program execution will be halted; otherwise program execution continues. A value of means that an error message is printed while a value of means that it is not.
If halting is not appropriate, the value or is recommended. If message printing is undesirable, then the value is recommended. Otherwise, the value is recommended since useful values can be provided in some output arguments even when on exit. When the value or is used it is essential to test the value of ifail on exit.
On exit: unless the routine detects an error or a warning has been flagged (see Section 6).
6Error Indicators and Warnings
If on entry or , explanatory error messages are output on the current error message unit (as defined by x04aaf).
Errors or warnings detected by the routine:
Note: in some cases e04rwf may return useful information.
The supplied handle does not define a valid handle to the data structure for the NAG optimization modelling suite. It has not been properly initialized or it has been corrupted.
On entry, , expected . Constraint: liarr must match the size of the data identified in cmdstr.
Reading mode is not supported for the given cmdstr.
Writing mode is not supported for the given cmdstr.
The request cannot be processed at this phase.
The requested information is not available.
An unexpected error has been triggered by this routine. Please
See Section 7 in the Introduction to the NAG Library FL Interface for further information.
Your licence key may have expired or may not have been installed correctly.
See Section 8 in the Introduction to the NAG Library FL Interface for further information.
Dynamic memory allocation failed.
See Section 9 in the Introduction to the NAG Library FL Interface for further information.
8Parallelism and Performance
Background information to multithreading can be found in the Multithreading documentation.
e04rwf is threaded by NAG for parallel execution in multithreaded implementations of the NAG Library.
e04rwf makes calls to BLAS and/or LAPACK routines, which may be threaded within the vendor library used by this implementation. Consult the documentation for the vendor library for further information.
Please consult the X06 Chapter Introduction for information on how to control and interrogate the OpenMP environment used within this routine. Please also consult the Users' Note for your implementation for any additional implementation-specific information.