e04rzf is a part of the NAG optimization modelling suite. It is used to deallocate the memory used within the problem handle and to destroy the handle itself.

2 Specification

Fortran Interface

Subroutine e04rzf (

handle, ifail)

Integer, Intent (Inout)	::	ifail
Type (c_ptr), Intent (Inout)	::	handle

C Header Interface

#include <nag.h>

void	e04rzf_ (void *handle, Integer ifail)

The routine may be called by the names e04rzf or nagf_opt_handle_free.

3 Description

Each problem handle initialized by e04raf should be deallocated to avoid memory leaks. Therefore e04rzf should be called on all the handles which are no longer needed, typically after obtaining results from the solver. Please note that passing a handle which has not been initialized by e04raf might cause unpredictable behaviour, including a crash of your program. See Section 3.1 in the E04 Chapter Introduction for more details about the NAG optimization modelling suite.

4 References

None.

5 Arguments

1: $handle$ – Type (c_ptr) Input/Output: On entry: the handle to the problem. It needs to be initialized (e.g., by e04raf) and must not be changed between calls to the NAG optimization modelling suite.

On exit: the handle is destroyed and set to c_null_ptr.
2: $ifail$ – Integer Input/Output: On entry: ifail must be set to $0$ , $- 1$ or $1$ to set behaviour on detection of an error; these values have no effect when no error is detected.
A value of $0$ causes the printing of an error message and program execution will be halted; otherwise program execution continues. A value of $- 1$ means that an error message is printed while a value of $1$ means that it is not.

If halting is not appropriate, the value $- 1$ or $1$ is recommended. If message printing is undesirable, then the value $1$ is recommended. Otherwise, the value $0$ is recommended. When the value $- 1$ or $1$ is used it is essential to test the value of ifail on exit.

On exit: $ifail = 0$ unless the routine detects an error or a warning has been flagged (see Section 6).

6 Error Indicators and Warnings

If on entry

ifail = 0

- 1

, explanatory error messages are output on the current error message unit (as defined by x04aaf).

Errors or warnings detected by the routine:

$ifail = 1$: The supplied handle does not define a valid handle to the data structure for the NAG optimization modelling suite. It has not been initialized by e04raf or it has been corrupted.

$ifail = - 99$: An unexpected error has been triggered by this routine. Please contact NAG.
See Section 7 in the Introduction to the NAG Library FL Interface for further information.

$ifail = - 399$: Your licence key may have expired or may not have been installed correctly.
See Section 8 in the Introduction to the NAG Library FL Interface for further information.