1: $x$ – Real (Kind=nag_wp) Input: On entry: the argument $x$ of the function.
2: $ifail$ – Integer Input/Output: On entry: ifail must be set to $0$ , $- 1 or 1$ . If you are unfamiliar with this argument you should refer to Section 4 in the Introduction to the NAG Library FL Interface for details.
For environments where it might be inappropriate to halt program execution when an error is detected, the value $- 1 or 1$ is recommended. If the output of error messages is undesirable, then the value $1$ is recommended. Otherwise, if you are not familiar with this argument, the recommended value is $0$ . When the value $- 1 or 1$ is used it is essential to test the value of ifail on exit.

On exit: $ifail = 0$ unless the routine detects an error or a warning has been flagged (see Section 6).

6 Error Indicators and Warnings

None.

7 Accuracy

δ

and

ε

are the relative errors in the argument and the result respectively, then in principle,

|ε| ≃ |\frac{2 x}{\sinh 2 x} δ| .

That is, a relative error in the argument,

x

, is amplified by a factor approximately

\frac{2 x}{\sinh 2 x}

, in the result.

The equality should hold if

δ

is greater than the machine precision (

δ

due to data errors etc.) but if

δ

is due simply to the round-off in the machine representation it is possible that an extra figure may be lost in internal calculation round-off.

The behaviour of the amplification factor is shown in the following graph:

Figure 1

It should be noted that this factor is always less than or equal to

1.0

and away from

x = 0

the accuracy will eventually be limited entirely by the precision of machine representation.

s10aaf is not threaded in any implementation.

None.

This example reads values of the argument

x

from a file, evaluates the function at each value of

x

and prints the results.

Interfaces: FL CL AD

s10aa: FL CL AD