G08CJF (PDF version)
G08 Chapter Contents
G08 Chapter Introduction
NAG Library Manual

NAG Library Routine Document


Note:  before using this routine, please read the Users' Note for your implementation to check the interpretation of bold italicised terms and other implementation-dependent details.

+ Contents

    1  Purpose
    7  Accuracy

1  Purpose

G08CJF calculates the Anderson–Darling goodness-of-fit test statistic and its probability for the case of standard uniformly distributed data.

2  Specification

REAL (KIND=nag_wp)  Y(N), A2, P

3  Description

Calculates the Anderson–Darling test statistic A2 (see G08CHF) and its upper tail probability by using the approximation method of Marsaglia and Marsaglia (2004) for the case of uniformly distributed data.

4  References

Anderson T W and Darling D A (1952) Asymptotic theory of certain ‘goodness-of-fit’ criteria based on stochastic processes Annals of Mathematical Statistics 23 193–212
Marsaglia G and Marsaglia J (2004) Evaluating the Anderson–Darling distribution J. Statist. Software 9(2)

5  Parameters

1:     N – INTEGERInput
On entry: n, the number of observations.
Constraint: N>1.
2:     ISSORT – LOGICALInput
On entry: set ISSORT=.TRUE. if the observations are sorted in ascending order; otherwise the routine will sort the observations.
3:     Y(N) – REAL (KIND=nag_wp) arrayInput/Output
On entry: yi, for i=1,2,,n, the n observations.
On exit: if ISSORT=.FALSE., the data sorted in ascending order; otherwise the array is unchanged.
Constraint: if ISSORT=.TRUE., the values must be sorted in ascending order. Each yi must lie in the interval 0,1.
4:     A2 – REAL (KIND=nag_wp)Output
On exit: A2, the Anderson–Darling test statistic.
5:     P – REAL (KIND=nag_wp)Output
On exit: p, the upper tail probability for A2.
6:     IFAIL – INTEGERInput/Output
On entry: IFAIL must be set to 0, -1​ or ​1. If you are unfamiliar with this parameter you should refer to Section 3.3 in the Essential Introduction for details.
For environments where it might be inappropriate to halt program execution when an error is detected, the value -1​ or ​1 is recommended. If the output of error messages is undesirable, then the value 1 is recommended. Otherwise, if you are not familiar with this parameter, the recommended value is 0. When the value -1​ or ​1 is used it is essential to test the value of IFAIL on exit.
On exit: IFAIL=0 unless the routine detects an error or a warning has been flagged (see Section 6).

6  Error Indicators and Warnings

If on entry IFAIL=0 or -1, explanatory error messages are output on the current error message unit (as defined by X04AAF).
Errors or warnings detected by the routine:
On entry,N<2.
The data in Y is not sorted in ascending order.
The data in Y must lie in the interval 0,1.

7  Accuracy

Probabilities greater than approximately 0.09 are accurate to five decimal places; lower value probabilities are accurate to six decimal places.

8  Further Comments


9  Example

This example calculates the A2 statistic and its p-value for uniform data obtained by transforming exponential variates.

9.1  Program Text

Program Text (g08cjfe.f90)

9.2  Program Data

Program Data (g08cjfe.d)

9.3  Program Results

Program Results (g08cjfe.r)

G08CJF (PDF version)
G08 Chapter Contents
G08 Chapter Introduction
NAG Library Manual

© The Numerical Algorithms Group Ltd, Oxford, UK. 2012