NAG Library Routine Document

G05SQF

One of the initialization routines G05KFF (for a repeatable sequence if computed sequentially) or G05KGF (for a non-repeatable sequence) must be called prior to the first call to G05SQF.

4 References

Knuth D E (1981) The Art of Computer Programming (Volume 2) (2nd Edition) Addison–Wesley

5 Parameters

1: N – INTEGERInput: On entry: $n$ , the number of pseudorandom numbers to be generated.
Constraint: $N \geq 0$ .
2: A – REAL (KIND=nag_wp)Input
3: B – REAL (KIND=nag_wp)Input: On entry: the end points $a$ and $b$ of the uniform distribution.
Constraint: $A \leq B$ .
4: STATE( $*$ ) – INTEGER arrayCommunication Array: Note: the actual argument supplied must be the array STATE supplied to the initialization routines G05KFF or G05KGF.
On entry: contains information on the selected base generator and its current state.

On exit: contains updated information on the state of the generator.
5: X(N) – REAL (KIND=nag_wp) arrayOutput: On exit: the $n$ pseudorandom numbers from the specified uniform distribution.
6: IFAIL – INTEGERInput/Output: On entry: IFAIL must be set to $0$ , $- 1 or 1$ . If you are unfamiliar with this parameter you should refer to Section 3.3 in the Essential Introduction for details.
For environments where it might be inappropriate to halt program execution when an error is detected, the value $- 1 or 1$ is recommended. If the output of error messages is undesirable, then the value $1$ is recommended. Otherwise, if you are not familiar with this parameter, the recommended value is $0$ . When the value $- 1 or 1$ is used it is essential to test the value of IFAIL on exit.

On exit: $IFAIL = 0$ unless the routine detects an error or a warning has been flagged (see Section 6).

6 Error Indicators and Warnings

If on entry

IFAIL = 0

- 1

, explanatory error messages are output on the current error message unit (as defined by X04AAF).

Errors or warnings detected by the routine:

$IFAIL = 1$: On entry, $N < 0$ .

$IFAIL = 3$: On entry, $B < A$ .

$IFAIL = 4$

On entry,

STATE vector was not initialized or has been corrupted.

7 Accuracy

Not applicable.

8 Further Comments

Although

y_{i}

takes a value from the half closed interval

(0, 1]

and

x_{i} = a + (b - a) y_{i}

x_{i}

is documented as taking values from the closed interval

[a, b]

. This is because for some values of

a

and

b

, G05SQF may return a value of

a

due to numerical rounding.

9 Example

This example prints five pseudorandom numbers from a uniform distribution between

- 1.0

and

1.0

, generated by a single call to G05SQF, after initialization by G05KFF.

NAG Library Routine DocumentG05SQF

+− Contents

1 Purpose

2 Specification

3 Description