NAG Library Routine Document

E04WCF

1  Purpose

2  Specification

3  Description

4  References

5  Parameters

1:     IW(LENIW) – INTEGER arrayCommunication Array

2:     LENIW – INTEGERInput

On entry: the dimension of the array IW as declared in the (sub)program from which E04WCF is called.

Constraint: $\mathbf{LENIW}\ge 600$, see routine E04WDF.

3:     RW(LENRW) – REAL (KIND=nag_wp) arrayCommunication Array

4:     LENRW – INTEGERInput

On entry: the dimension of the array RW as declared in the (sub)program from which E04WCF is called.

Constraint: $\mathbf{LENRW}\ge 600$, see routine E04WDF.

5:     IFAIL – INTEGERInput/Output

On entry: IFAIL must be set to $0$, $-1\text{ or }1$. If you are unfamiliar with this parameter you should refer to Section 3.3 in the Essential Introduction for details.

For environments where it might be inappropriate to halt program execution when an error is detected, the value $-1\text{ or }1$ is recommended. If the output of error messages is undesirable, then the value $1$ is recommended. Otherwise, if you are not familiar with this parameter, the recommended value is $0$. When the value $-\mathbf{1}\text{ or }\mathbf{1}$ is used it is essential to test the value of IFAIL on exit.

On exit: $\mathbf{IFAIL}=\mathbf{0}$ unless the routine detects an error or a warning has been flagged (see Section 6).

6  Error Indicators and Warnings

$\mathbf{IFAIL}=1$

One or more of the communication array lengths LENIW or LENRW is less than $600$.

7  Accuracy

8  Further Comments

9  Example